In order to carry through remote digital communication between computers with various standard series interfaces converter facilities or intelligent instruments, it needs inter exchange of standard series interface converter of compatible USB and RS-485 standard is able to convert mono-end USB signal to balance difference RS-485 signal and extend the communication distance to 1.2km. No external power but adopts a particular USB charge pump to drive the system, and gains electricity without initializing the USB series interface. An internal zero delay auto transceiver and particular I/O circuit automatically control the data streamdirection in stead of an handshake signal (for example RTS,DTR etc).There by in guarantees the function under RS-485 without changing the program compiled under RS-485 half-duplex mode and assures the adaptation to current operation software and interface hardware.         

The transmission rate of 300-921.6kbps. Is capable of applying between host computers,host computer and is extensions or external equipment and forms dot to dot, dot to dots remote and multi-communication network, It implements multi-machine response communica tion and commonly used in systems of industrial automation control all-one-card. Door safe, car parking, ATM, bus charge, eatery sell out, staff attendance management, and toll highway etc.

2.Capabilities parameter

Interface feature: USB Ver1.1 2.0,RS-485 standard interface compatible with EIA,TIA

Electric interface: USBAconnector, RS-485 end DB9 needle connector, with connection pole

Working mode: asynchronismhalf-duplex difference transmission

Transmissionmedia: twisted -pair or STP

Transmission rate: 300-921.6KBPS

External discharge dimension: 55mmX36mmX18mm

Working circumstance : - 25 to 70 degree C, relative humidity 5% to 95%

Transmission distance: 1,200mm(RS-485 end),5m(RS-232 end)

3. Connector an signal

RS-485 data output & connector and bay-line distribution

4.Hardware installation & application

The product exterior adopts USB to DB-9 all-purpose transit plugs, output plug carries ordinary connection pole, can use TP or STP and easy connection and disassembly, T/R+\T/R- stands for dispatching A+\B-,VCC stands for standby power input, GND stands for public ground wire, Dot to dot, dot to dots, halfduplex communication need 2 connection (T/R+\T/R-),connection

principle is T/R+ connects to opposite T/R+\T/R- connects to opposite T/R-,RS-485 half-duplex mode connection is to connect T/R+ to opposite A+\and T/R-to opposite B-. Remark:A+for(485+),B- for (485-)

UR485 interface supports 2 communication modes as below

1.Dot to dot 2 wires half-duplex

2.Dot to dots 2 wires half-duplex

When converter works under half-duplex connection, it needs to install a matching resistance (data 120 ohm1/4W) for preventing signal reflection and interference.

5. Communication sketch map

USB to RS-485 conversion

RS-485 dot to dot 2 wires half-duplex

RS-485 dot to dots 2 wires half-duplex

UR485 half-duplex communication connect between interface converter

6. Problemand resolution

1\data communication failure

A. Check if RS-232 interface connection is correct

B. Check if RS-232 output connection is correct

C. Check if connection ends are well connected

2\data loss or mistake

    A. Check if data rate and format is consistent on both communication end.